www.iFourWinns.com

Dedicated to Current and Future Owners
It is currently Mon May 12, 2025 5:45 am

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 72 posts ]  Go to page 1, 2, 3, 4, 5  Next
Author Message
PostPosted: Tue Aug 23, 2011 1:23 am 
Offline
email admin your custom rank

Joined: Wed Jun 22, 2011 2:33 am
Posts: 1026
Just wondering what you southern boaters are doing to get your boats safe.


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 5:57 am 
Offline
268 Vista

Joined: Tue May 16, 2006 9:49 am
Posts: 4989
Location: West Michigan
Most of them are probably pulling their boats out of the water, instead of digging up posts from months and years ago, every night after they get home from work. :roll:

_________________
One of 4 Previous (Sold) Boats:
2000 Four Winns 268 Vista
Image
Current Boat: 2004 Chaparral 235 ssi cuddy
Image


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 6:39 am 
Offline
email admin your custom rank

Joined: Wed Jun 01, 2011 10:21 am
Posts: 5667
Location: Austin, TX
I live in Orlando.

Not sure yet.

_________________
1981 Columbia 8.7
2015 Yamaha FZR - 87mph - sold
2006 Yamaha GP1300R - sold
2003 Chaparral 215 SSI - sold
2009 Stingray 195CS - sold
2000 Four Winns H180 - sold
1976 O'day Daysailer II - sold

Rick's Four Winns H180 Mods/Upgrade Thread


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 7:18 am 
Offline
Shark
User avatar

Joined: Thu Oct 30, 2008 11:22 am
Posts: 125
Location: Durham, NC
Hovering in place for the moment. Hoping it doesn't go Cat 4 or higher and hoping it skirts the coast of Fl, GA, SC, and NC!

Good luck to all!

_________________
Jon & Rhonda
Image
'88 235 Sundowner
5.7L OMC Cobra
'01 F150 4.2L


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 7:20 am 
Offline
email admin your custom rank

Joined: Wed Jun 01, 2011 10:21 am
Posts: 5667
Location: Austin, TX
I keep my boat in an inland lake. Pulling it out tomorrow. You never know with these things.

_________________
1981 Columbia 8.7
2015 Yamaha FZR - 87mph - sold
2006 Yamaha GP1300R - sold
2003 Chaparral 215 SSI - sold
2009 Stingray 195CS - sold
2000 Four Winns H180 - sold
1976 O'day Daysailer II - sold

Rick's Four Winns H180 Mods/Upgrade Thread


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 7:22 am 
Offline
email admin your custom rank
User avatar

Joined: Mon Oct 27, 2008 7:13 pm
Posts: 1303
Location: Allatoona Lake, Georgia
LOL Cap'n because I have noticed that as well. I personally liked the "Snowing Again" thread from 2 1/2 years ago. As for preparing for the hurricane, when I was a two boat owner, I used to kid around and tell everyone I was going to haul my 298 Vista to where the hurricane was going to hit and hope for the best. :lol: Knowing my luck though, my boat would just get a bunch of damage and I would have to come out of pocket for the deductible and be stuck with an inferior product. I heard that some coastal insurance policies will pay for you to haul your boat out. Makes sense.

_________________
Image
Current Boat: 2000 Four Winns 298 Vista
Previous Boat: 2000 Carver 406MY


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 8:23 am 
Offline
268 Vista

Joined: Tue May 16, 2006 9:49 am
Posts: 4989
Location: West Michigan
If your boat is in the water at a slip, there's plenty that you can do before the high winds hit. For starters, remove everything that can possibly catch the breeze. All canvas—biminis, isinglass and cockpit covers and their supporting frameworks—must come off. Additionally, wind-catching extensions like outriggers, moveable antennas and even anchors should be stowed aboard or ashore. Remember, a 60-mph breeze can tip a Volkswagen over and a 100-mph wind can carry it away, but not make the payments.

All lines should be doubled and made of nylon, not Dacron and never polypropylene. Lines should be of the largest diameter possible. But they shouldn't be so thick that you can't wrap one around the base of a cleat and form two figure eights. This is important because the lines will serve to "sling the boat in the slip. Fore and aft spring lines should be made up to the outlying pilings—the longer and at the most acute angle, the better. Therefore, springs from the bow and stern cleats should be made up to pilings as far forward and aft as possible; the same holds true in slips with bollards or cleats on the dock. Bow and stern lines should have enough slack in them to compensate for the greatest expected tidal change and be long enough to keep the boat from hitting the adjoining dock/pilings. It's the springs that will do most of the work. Ideally, you'll need to pull a line in to step off the boat and onto the dock when you're done. The spring action of the lines should pull the boat back and allow it to sit suspended in the middle of the slip (you'll still need fender boards). Naturally, wherever a line touches the boat, dock or another line, it must be chafe-protected—split garden hose, leather or even rags that are taped or sewn in place are ideal.

_________________
One of 4 Previous (Sold) Boats:
2000 Four Winns 268 Vista
Image
Current Boat: 2004 Chaparral 235 ssi cuddy
Image


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 8:25 am 
Offline
Nauti Luv

Joined: Mon Jan 05, 2009 9:55 am
Posts: 2186
Location: Little Elm - Lake Lewisville TX
I'm pretty prepared. I went down to the boat last night to stock some drinks,set the AC to 90 degrees (cabin was 105!!!), and put the cover on. Were going to ride it out. :D

_________________
Current Boat:
2004 Sea Ray 320 Sundancer "Nauti Luvin'"

Previous Boats:
1999 298 Vista "Seas The Day"
2008 H200SS "Nauti Luv"
2006 Tahoe Q4


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 8:44 am 
Offline
email admin your custom rank

Joined: Sun Nov 21, 2010 8:03 am
Posts: 2238
Location: Winthrop, Ma.
Cap'n Morgan wrote:
If your boat is in the water at a slip, there's plenty that you can do before the high winds hit. For starters, remove everything that can possibly catch the breeze. All canvas—biminis, isinglass and cockpit covers and their supporting frameworks—must come off. Additionally, wind-catching extensions like outriggers, moveable antennas and even anchors should be stowed aboard or ashore. Remember, a 60-mph breeze can tip a Volkswagen over and a 100-mph wind can carry it away, but not make the payments.

All lines should be doubled and made of nylon, not Dacron and never polypropylene. Lines should be of the largest diameter possible. But they shouldn't be so thick that you can't wrap one around the base of a cleat and form two figure eights. This is important because the lines will serve to "sling the boat in the slip. Fore and aft spring lines should be made up to the outlying pilings—the longer and at the most acute angle, the better. Therefore, springs from the bow and stern cleats should be made up to pilings as far forward and aft as possible; the same holds true in slips with bollards or cleats on the dock. Bow and stern lines should have enough slack in them to compensate for the greatest expected tidal change and be long enough to keep the boat from hitting the adjoining dock/pilings. It's the springs that will do most of the work. Ideally, you'll need to pull a line in to step off the boat and onto the dock when you're done. The spring action of the lines should pull the boat back and allow it to sit suspended in the middle of the slip (you'll still need fender boards). Naturally, wherever a line touches the boat, dock or another line, it must be chafe-protected—split garden hose, leather or even rags that are taped or sewn in place are ideal.


If you need to do all that, than at least you're boat should be on it's mooring. At best, out of the water and into land.
It goes without saying, on the mooring, your boat will alway be into the wind. Which will result in less damage. At the slip, your boat could be broad side to the wind. Putting even more stress on the cleats, risking both dock and boat slaming into each other. Plus, I am sure that they will call for all boats to leave there slips on a 60+ winds


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 8:47 am 
Offline
email admin your custom rank

Joined: Wed Jun 01, 2011 10:21 am
Posts: 5667
Location: Austin, TX
Safety in numbers....

Image

_________________
1981 Columbia 8.7
2015 Yamaha FZR - 87mph - sold
2006 Yamaha GP1300R - sold
2003 Chaparral 215 SSI - sold
2009 Stingray 195CS - sold
2000 Four Winns H180 - sold
1976 O'day Daysailer II - sold

Rick's Four Winns H180 Mods/Upgrade Thread


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 10:13 am 
Offline
email admin your custom rank

Joined: Sun Nov 21, 2010 8:03 am
Posts: 2238
Location: Winthrop, Ma.
"At best, out of the water and into land."


Did you notice, that there all sail boats but one!! There a little harder to pull out of the water.


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 9:42 pm 
Offline
email admin your custom rank

Joined: Wed Jun 22, 2011 2:33 am
Posts: 1026
Cap'n Morgan wrote:
Most of them are probably pulling their boats out of the water, instead of digging up posts from months and years ago, every night after they get home from work. :roll:



LMAO! Too funny I was wondering when someone was going to mention that. I am a new boater and I am definitely interested in every single story that you guys post because the knowledge that you pass on to someone like me is priceless! Something one of you guys post might save my life one day, that is how I look at it and yes I know I have the new boat jitters but you remember how you felt when you got your first boat. Working graveyard you have to do something to stay awake in this cramped office on wheels. Lots of great information and it seems Irene will be headed up to North Carolina it seems we will have to see. 8) Joe in Miami


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 10:11 pm 
Offline
email admin your custom rank

Joined: Wed Jun 01, 2011 10:21 am
Posts: 5667
Location: Austin, TX
Well, being here in Orlando I'm starting to get prepared. Got a few cases of beer, food to grill, and a kite

_________________
1981 Columbia 8.7
2015 Yamaha FZR - 87mph - sold
2006 Yamaha GP1300R - sold
2003 Chaparral 215 SSI - sold
2009 Stingray 195CS - sold
2000 Four Winns H180 - sold
1976 O'day Daysailer II - sold

Rick's Four Winns H180 Mods/Upgrade Thread


Top
 Profile  
 
PostPosted: Tue Aug 23, 2011 10:55 pm 
Offline
email admin your custom rank

Joined: Wed Jun 22, 2011 2:33 am
Posts: 1026
I fired up the generator today and glad I tried to because the battery was dead and wouldn't take a charge. 45 dollars later a gallon of gas and she fired up no problem left her running for 30 minutes hooked up to my portable ac unit. Quick trip to costco and my beer supply is on par to barter if need be lol. Gas in my container in the shed, the boat is tied up tight on the trailer, cars ready to ride out with no gas for a week if need be. Freezer stocked with goodies for two weeks or more. I am ready for Irene but glad that she is taking a turn to the east. Good luck in Orlando 8)


Top
 Profile  
 
PostPosted: Wed Aug 24, 2011 8:26 am 
Offline
email admin your custom rank

Joined: Sun Nov 21, 2010 8:03 am
Posts: 2238
Location: Winthrop, Ma.
Well so far her in Boston, everyone is planning!! As of RIGHT now, my plan is to bring the trailer this weekend and on Sunday, pull the boat out. If it tracks more east, than on the mooring. Right now, its a waiting game.

I don't have a generator for the house. I have alway thought about getting one, but in all the years, we really never needed one. I gusse, thats a good thing. But, some of the tracks, buts the storm right though Boston. So I am sure if that happens, we will be with out power for days!!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 72 posts ]  Go to page 1, 2, 3, 4, 5  Next

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 14 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group