www.iFourWinns.com • View topic

View unanswered posts | View active topics

Board index » Boat Accessories » Electrical Stuff

All times are UTC - 6 hours [ DST ]

Depth Sounder

Page 1 of 1

[ 7 posts ]

Print view

Previous topic | Next topic

Author

Message

Barefoot

Post subject: Depth Sounder

Posted: Fri Nov 25, 2011 9:48 pm

Clownfish

Joined: Wed May 17, 2006 8:19 pm
Posts: 40
Location: California

Thought I would throw this out to you experts. The depth sounder on my 1999 200 horizon with the infamous VDO gauge cluster has become intermittant. When you first turn on the ignition it displays normally then after starting the engine it will only display dashed lines (----). Any suggustions?

Ross

_________________
1999 200 Horizon

Top

Paul I.

Post subject: Re: Depth Sounder

Posted: Sat Nov 26, 2011 7:21 am

email admin your custom rank

Joined: Sun Nov 21, 2010 8:03 am
Posts: 2238
Location: Winthrop, Ma.

Is the transducer clean?? I would go over all the connectors and use dielectric grease on them.

Top

Barefoot

Post subject: Re: Depth Sounder

Posted: Sat Nov 26, 2011 10:46 am

Clownfish

Joined: Wed May 17, 2006 8:19 pm
Posts: 40
Location: California

The transducer is clean, I tried that right away. I only found one connector from the transducer to the harness in the engine compartment and checked it. Whats wierd about this is it works with the key on and all through the engine cranking but as soon as the engine starts and the key is released it shows the dashed lines. I was wondering if there is a rely somewhere that switches the power source i.e. from battery to altenator after engine start.

Ross

_________________
1999 200 Horizon

Top

St. Louis Dave

Post subject: Re: Depth Sounder

Posted: Sun Nov 27, 2011 10:06 am

Lake Michigan - Unsalted

Joined: Wed Nov 14, 2007 11:38 pm
Posts: 867
Location: Comstock Park / Grand Haven (Barretts)

Check you ground connection and make sure it is tight. I'd also make sure everything back of the VDO Cluster is tight too. Welcome to the world of FourWinns VDO clusters.

_________________
2001 Horizon 260 - 7.4 Volvo GSI DP

Top

Barefoot

Post subject: Re: Depth Sounder

Posted: Sun Dec 04, 2011 11:09 am

Clownfish

Joined: Wed May 17, 2006 8:19 pm
Posts: 40
Location: California

I have checked the connections at the cluster and I thought the ground was common to the entire cluster which is working properly except for the depth sounder. Thought about replacing the transducer but if it's bad you would think it would be bad all the time not just after engine start. Has me baffled!!

Ross

_________________
1999 200 Horizon

Top

Paul I.

Post subject: Re: Depth Sounder

Posted: Mon Dec 05, 2011 2:40 pm

email admin your custom rank

Joined: Sun Nov 21, 2010 8:03 am
Posts: 2238
Location: Winthrop, Ma.

Check the voltage before & after starting. Are they the same?? If not, try another POS feed point, than another ground point. You could try, powering it directly off the battery.

Top

scottmph

Post subject: Re: Depth Sounder

Posted: Tue Aug 21, 2012 2:28 pm

I fix stuff

Joined: Wed Jun 21, 2006 3:40 pm
Posts: 375
Location: Euless (TX)

maximac wrote:

# Depth Range: 1-61 meters (3-199 feet)
# Deep and Shallow water alarmsThe Faria Depth Sounder has a multi-line LCD that displays ambient air temp or water temp at the touch of a button. Reads depths from 3 feet to 199 feet in meters, fathoms, and feet.

BANNED

_________________
2006 FW 203 FS
2005 Dodge Laramie 1500
2003 CRF 247F SuperMoto racer
2001 CBR1100XX

Top

Page 1 of 1

[ 7 posts ]

Board index » Boat Accessories » Electrical Stuff

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum